MGRIP PRO | M-LOK ANGLED FOREGRIP
Most foregrips clamp hard plastic straight against your handguard and scuff the finish. The DSNRARMS MGRIP Pro has a silicone layer between the grip and the handguard, so mounting it does not leave ring marks on your anodizing or Cerakote. It also adds friction at the joint so the grip stays put.
The vertical geometry gives you a straight, squared-up hold, and the waisted upper section clears the handguard so your hand has somewhere natural to sit. Horizontal ribs run across the lower body, and a raised stippled panel sits on each side where your palm actually makes contact. That stippling is part of the geometry itself, not tape, so there is nothing to peel off.
Every one is manufactured to order in Austin, Texas.
Product Specifications:
| Mount | M-LOK, direct attach |
| Orientation | Vertical |
| Interface | Silicone anti-scratch layer |
| Texture | Stippled side panels, ribbed lower body |
| Hardware | MLOK installation hardware included |
| Material | High Strength Polymer |
| Height | 80 mm (3.15 in) |
| Length | 42 mm (1.65 in) |
| Width | 25 mm (0.98 in) |
| Finishes | Black, Tan, White |
| Manufactured in | Austin, Texas |
Product features
Silicone anti-scratch layer.
A silicone barrier sits between the grip and your handguard, so mounting it does not leave marks on your rifle's finish.
Direct M-LOK attachment.
Mounts straight to the M-LOK slot with the included hardware. There is no rail section or adapter to buy.
Stippled side panels.
A raised stipple panel on each side sits where your palm and fingertips land, and it is formed into the geometry rather than applied as tape.
Ribbed lower body.
Horizontal ribs run across the lower section and give you a consistent index with a bare hand or a glove.
Vertical geometry.
A straight, squared hold that suits a forward stance and a high thumb.
Made in Austin, Texas.
Manufactured to order, inspected, and packed by hand.